My Titan 50 tail pulley pin missing in flight

 This cheap 600mm Turnigy carbon fiber blade with wire inside the leading edge....

Root cause... The pin was missing....

Jai's New Avant 90

Break-in

Hj. Wahid starting his TZV2 Frenzy 50 watched by Tommy.... Future RC pilot.

Yakip (yellow cap) the new KB flyer..... Manny setting Yakip's HK500.

Trex 600 NSP Cooling Fan Broken

http://www.hobbyking.com/buddy.asp?code=B842191C-5A03-4787-8FE6-EBA90A02E808

1st May flight in G17

HK-7X 2.4Ghz 7 channels radio

A reliable 7ch, 5 model 2.4Ghz transmitter system (version 2).
Hobby King HK-7X 2.4Ghz system is an pro level transmitter offering the reliability of 2.4Ghz spread spectrum technology and comes with a 8ch receiver. HK-7X can support all aircraft types, it features quick response, high precision

Features:

LED display, Show model type and battery voltage on normal status.
5 models parameters store supported
Support HELI(helicopter) mode and AERO mode. Following mode is supported in each mode.

Heli mode:
HP1 : Normal helicopter with 1 servo
HP2: Swash helicopter with 2 servos
HP3: CCPM 120 swash helicopter with 3 servos
AERO mode:

AP: Normal aero plane
VP : V-tail plane
DP: Del ta wing plane

7 channels standard servo signal output

Support 5 points throttle(THR) curve on NORMAL mode and IDLE mode.
Support 5 points pitch(PIT) curve on NORMAL mode, IDLE mode and HOLD mode.
Set reverse (REV), sub trim (SUB) and travel by LED and button.
Dual rate (DR) control supported
Throttlehold supported
Gyro sensitivity adjust supported
Return to battery voltage display after no operation till 30 seconds.
Beep when battery voltage low than 8.6V (Once per second).

Included;
1 x 2.4Ghz transmitter
1 x 2.4Ghz Receiver
1 x Bind Plug

1x Manual

Note:
Only HK-8X receiver is comptible with HK-7X transmitter.

Only HK-8R receiver is compatible with the HK-6X transmitter.

Only HK-8Xv2 receiver is compatible with the HK-7Xv2 transmitter.

Exhibition at OGDC Seria 2nd April 2011

Frenzy 50 crashed (2nd crashed)

ProFlight Simulator

Click Here!

.50 size Flybarless head systems for 10mm main shaft - Trex 600/600N

.50 size Flybarless head systems for 10mm main shaft - Trex 600/600N

Upgrade Flybarless rotor head for.50 Nitro or 550/600 Electric Helicopter.

Can be used on Trex 600E/ 600N, Raptor 50, Compass Models Knight 50N/ 600E, RJX Xtreme 50, Outrage 550, JR Vibe 50 and most other 50N or 600E helicopters usinga 10mm main shaft.

More....

OrangeRx Spektrum DSM2 Compatible 6Ch 2.4Ghz Receiver

Compatible with all Spektrum DSM2 Air transmitters.
The new range of OrangeRx receivers are built using original components and MCUs and with state of the art SMT automation to ensure a quality product each and every time.
All OrangeRx receivers are QC tested before leaving the factory.
The OrangeRx will work with ANY Aircraft Spektrum DSM2 2.4Ghz transmitter
The OrangeRx 6ch is only 3.7g in weight and 19.5x30x10mm in size. Great for small planes, helis, parkflyers or even medium sized sport planes.

Key features.
Super light weight 3.7g / 9.8 grams with case.
Compatible with DSM2 aircraft radio and module systems.
6 Channels.
Compact design 19.5mm x 30mm x 10mm, with case 43x22x13mm.
Short 29mm antennas for mounting in almost any location.
Input voltage: 3.7~9.6V.
Satellite port included.

Warranty.
12 Month replacement guarantee!

Included.
OrangeRx-6 DSM2 Compatible receiver

NOTE
i) This is not a Spektrum receiver, nor is it a copy of a Spektrum Receiver.
The Spektrum brand is a trademark of Horizon Hobbies USA.
ii) Price of this receiver may fluctuate (up or down) due to cost of electronic components.
iii) This is not an underground manufactured fake Spektrum receiver. OrangeRx quality is guaranteed.

More here >>....

ALIGN TREX PARTS

More here.....